Spray the cleaned surface with a mixture of water and washing-up liquid. Add approx. 2 to 3 drops of detergent to 1 liter of water.
Place the sticker with the print facing downwards on a suitable surface and remove the paper from the adhesive surface." Place the sticker with the print facing downwards on a suitable surface and remove the paper from the adhesive surface.
Now spray the adhesive surface of the film with the mixture.
Now place the film sticker on the surface to be covered. For larger films, it is advisable to do this in pairs.
The sprayed mixture forms a film between the film and the surface to be covered so that the film can be easily pushed into the correct position.
Now use a felt squeegee and apply even pressure to remove the water from behind the film so that the film's adhesive can adhere to the surface.
Excess film can simply be cut off flush with the edge of the boat using a cutter knife.
For protruding edges, you can use the squeegee to help you cut and guide the blade along it.
You can also mark the desired cut edge with masking tape and then cut along it.
This means that large stickers can be perfectly adapted to the shape of the boat.
Finally, we recommend heating the edges of the stickers and pressing them on again with the squeegee.
We recommend coating the edges of the sticker in the area of the fairway with an edge sealant.