The stickers adhere to all smooth surfaces such as paint, gelcoat on GRP boats, bare aluminum and glass. For boats made of PE, you should first test the durability with a sample sticker.

We generally recommend sealing the edges of stickers that are bonded to bare aluminum. In the case of paint or gelcoat, sealing is only recommended in the area where the fairway presses against the boat. The areas that are underwater should also be coated with our edge sealant.

In general, the stickers can be applied wet or dry. Wet application is particularly advantageous for inexperienced users, as the film only adheres once the water has been squeezed out. If you add 1 to 2 drops of washing-up liquid to 1 liter in the spray bottle, the sticker can be easily pushed into position and, as soon as it is aligned, can be pressed on with a squeegee. It is important that the edges of the sticker are warmed up after application and pressed on properly. You can find detailed illustrated instructions here.

The surface to be covered should be thoroughly cleaned and degreased beforehand. We recommend sanding or filling in any deep scratches or unevenness beforehand.

Fish stickers usually take 5 to 7 working days to produce. First we print your motif in the desired size on a white film, then we laminate a transparent film over it. This protects the print and prevents it from fading due to UV radiation. We then place the film in the plotter, which cuts out the outer edge of your motif. Finally, the stickers are cut apart and packaged.

Our Boat stickers are made from the same high-quality film that we use for full boat wrapping. This is a protective laminated digital printing film.