Gluing instructions Inflatable boat registration number sticker
Here you can find out how to easily apply an Inflatable boat registration number sticker yourself using transfer film. We show you how to align the lettering precisely and stick it on securely.Attention Important: The adhesive reacts with the plasticizers in the PVC. For this reason, the sticker must be heated with a hairdryer after application and the inflatable boat must be inflated for at least 24 hours. After the 24 hours, the inflatable boat can be folded up as usual.

Font size
The specified height and width always refer to the total area of the font. Here in the example, "A" is the font height and B is the font width.

Font size
For a boat license plate, we recommend a font with digits of the same height.

Inflatable boat registration number sticker.
The inflatable boat must be free of dirt and grease. We recommend isopropanol. After cleaning, it is important that the surface is dry and there are no residues of the cleaner. Now you can start sticking on the Inflatable boat registration number stickers. Measure the lettering straight and fix it with Crepe tape.

Inflatable boat registration number sticker.
Once it is in the right position, fix it in the middle with Crepe tape.

Remove the lettering from the paper.
Now cut through the Crepe tape on one side and remove the lettering from the backing paper.

Cut the paper off the sticker.
Cut off the backing paper with scissors and fold the lettering back under slight tension.

Press down the license plate sticker.
Then squeegee the letters with even movements and light pressure.

Repeat the process and press on the entire license plate.
Next, repeat the process for the other side and then press the individual letters down firmly again.

Heat the transfer foil
The lettering and the transfer foil must now be heated with a hair dryer. A commercially available hair dryer on a warm setting is sufficient.

Press on the lettering
During and after blow-drying, the lettering must be pressed firmly into the material with your fingers. There must be no air between the structure of the material and the foil. The heated foil must now rest with the transfer foil for at least 1 hour and tighten.

Carefully remove the transfer foil
After the film has rested for at least 1 hour, the transfer film can be carefully removed.

Heat stickers
The film must then be reheated with a fon to activate the adhesive.

Press on the lettering
During and after blow-drying, the sticker must be pressed on firmly with your fingers. The film must be worked into the material. (There must be no air between the film and the material).

Inflatable boat registration number sticker inactive
The license plate must now be left for 24 hours. The adhesive needs 24 hours to develop its full strength. The inflatable boat must remain fully inflated.